Packet data access points
Press , and select
Tools
>
Settings
>
Connection
>
Access points
>
Options
>
Edit
or
New access point
.
Follow the instructions from your service provider.
●
Access point name
— You obtain the access
point name from your service provider.
●
User name
— The user name may be needed to
make a data connection, and is usually provided
by the service provider.
●
Prompt password
— If you must enter the
password every time you log in to a server, or if
you do not want to save your password in the
device, select
Yes
.
●
Password
— A password may be needed to
make a data connection and is usually provided
by the service provider.
●
Authentication
— Select
Secure
to always send
your password encrypted or
Normal
to send
your password encrypted when possible.
●
Homepage
— Depending on the access point
you are setting up, enter the web address or the
address of the multimedia messaging centre.
Select
Options
>
Advanced settings
to change
the following settings:
●
Network type
— Select the internet protocol
type to transfer data to and from your device. The
157
Se
ttings
other settings depend on the selected network
type.
●
Phone IP address
(for IPV4 only) — Enter the IP
address of your device.
●
DNS address
— Enter the IP addresses of the
primary and secondary DNS servers, if required
by your service provider. Contact your internet
service provider to obtain these addresses.
●
Proxy server address
— Enter the address of
the proxy server.
●
Proxy port number
— Enter the port number
of the proxy server.